MS 441 C-M
English
36
Starting the chain saw
WARNING
There must not be anyone within the
swivel range of the chain saw.
N Press the button, the
decompression valve will be
opened
The decompression valve is closed
automatically when the engine starts for
the first time. For this reason, press the
button again before each additional
starting procedure.
N Push the hand guard (1) forwards –
the saw chain is blocked
N Simultaneously press and hold
down the throttle trigger lockout (2)
and throttle trigger (3) – set master
control lever (4) to Start } and
simultaneously release throttle
trigger and throttle trigger lockout
N Hold and start the chain saw
Once the engine is running
N Simultaneously blip the throttle
trigger lockout and the throttle
trigger (2); the Master Control
lever (1) jumps to the operating
position F and the engine begins to
idle
N Pull the hand guard toward the
handlebar
The chain brake is released – the chain
saw is ready for use.
NOTICE
Open the throttle only when the chain
brake is off. Increased engine speeds
with the chain brake on (saw chain is
stationary) will quickly damage the
clutch and chain brake.
To Next Page
Loading...
