MSE 140 C, MSE 160 C, MSE 180 C, MSE 200 C
English
17
N Take out the screw (5).
N Line up the tensioning gear (6) and
guide bar (7).
N Insert the screw (8) and tighten it
down firmly.
Disengaging the chain brake.
N Pull the hand guard towards the
front handle until there is an audible
click – the chain brake is
disengaged.
Fitting the chain
Wear work gloves to protect your hands
from the sharp cutters.
N Fit the chain – start at the bar nose.
Pay attention to the position of the
tensioning gear and the cutting
edges.
N Turn the tensioning gear (1)
clockwise as far as stop.
N Turn the guide bar so that the
tensioning gear is facing you.
N Fit the chain over the sprocket (2).
N Push the guide bar over the bar
stud (3), the head of the rear bar
stud must engage the slot.
To Next Page
Loading...
