MSE 140 C, MSE 160 C, MSE 180 C, MSE 200 C
English
25
N Flip the bar – after each sharpening
and each time the chain is changed
– to avoid uneven wear, especially
at the sprocket nose and on the
bottom
N Periodically clean the oil inlet
hole (1), oil outlet channel (2) and
bar groove (3)
N Measure groove depth – using the
measuring tool on the file gauge
(special accessory) – in the area
with the greatest wear
If the groove is not at least this deep:
N Replace guide bar
Otherwise the drive links will grind
against the base of the groove – the
bottoms of the cutters and the tie straps
will not lie against the bar.
N Use a dry brush or similar tool to
clean the cooling slots at regular
intervals.
Taking Care of the Guide Bar
To Next Page
Loading...
