Stihl MSE 170 C User Manual

MSE 170 C, MSE 210 C
English
23
N Place the cap on the opening and
rotate it counterclockwise until it
engages the filler neck.
N Continue rotating the cap
counterclockwise (about a quarter
turn) – this causes the bottom of the
cap to be turned to the correct
position.
N Turn the cap clockwise and lock it in
position – see section on "Closing
the filler cap".
Checking oil level
N Check the oil level regularly during
operation.
N Top up the oil tank when the oil level
reaches the "min" mark (1) or
earlier.
If the oil level in the tank does not go
down, the reason may be a fault in the oil
supply system: Check chain lubrication,
clean the oilways, contact your dealer
for assistance if necessary STIHL
recommends that you have servicing
and repair work carried out exclusively
by an authorized STIHL servicing
dealer.
The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your saw without chain
lubrication. If the chain runs dry, the
whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
Left: Bottom of cap is twisted –
inner mark (1) in line with
outer mark.
Right: Bottom of cap in correct posi
-
tion – inner mark is under the
grip. It is not in line with the
outer mark.
1
001BA238 KN
001BA256 KN
9931BA040 KN
1
Checking Chain Lubrication
143BA024 KN

Stihl MSE 170 C Specifications

General

Brand	Stihl
Model	MSE 170 C
Category	Chainsaw
Language	English