Stihl RE 282 PLUS - User Manual

Questions and Answers

G
Gary MillerAug 18, 2025
Why does my Stihl Pressure Washer motor hum but not run when switched on?
- M
  Matthew JacksonAug 18, 2025
  The Stihl Pressure Washer motor may hum but not run due to several reasons: the mains voltage may be too low or improper (check the electrical connection, plug, cable, and switch); the extension cord may have the wrong cross-section (use an extension cord with a sufficient cross-section); the extension cord may be too long (connect the machine without an extension cord or with a shorter one); the mains circuit-breaker may have been tripped (switch off the machine, actuate the spray gun until water only drips out of the head, engage the safety catch, reset the mains circuit-breaker); or the spray gun may not be actuated (actuate the spray gun when switching on the machine).
L
Laura GuerreroAug 20, 2025
Why does my Stihl RE 282 PLUS Washer engine keep stopping?
- S
  stephen66Aug 20, 2025
  If the engine of your Stihl Washer stops, it might be due to the motor overheating. Check whether the supply voltage and machine voltage match, and let the motor cool down for at least 5 minutes.
K
karendunnAug 23, 2025
Why does the pressure fluctuate or drop in my Stihl Pressure Washer?
- L
  Lydia PruittAug 23, 2025
  Pressure fluctuations or drops in your Stihl Pressure Washer could be due to: - Shortage of water (open the water tap completely and comply with permissible suction lift if using suction mode). - A dirty high-pressure nozzle in the spray head (clean the high-pressure nozzle). - A clogged water intake strainer in the pump inflow (clean the water intake strainer). - A dirty water filter at the pump intake (clean the water filter). - A clogged nozzle (clean the nozzle). - A leaky high-pressure pump or defective valves (have the machine checked by a servicing dealer).
A
Alicia SmithAug 26, 2025
What to do if my Stihl Pressure Washer is not supplying detergent?
- W
  William FarmerAug 26, 2025
  If your Stihl Pressure Washer is not supplying detergent, the detergent tank may be empty (fill the detergent tank), the detergent intake may be clogged (eliminate the clog), or the injector may be worn (have the machine checked by a servicing dealer).
S
Susan WalterAug 28, 2025
Why does my Stihl Pressure Washer motor constantly switch on and off?
- A
  Amanda MartinezAug 28, 2025
  If the motor of your Stihl Pressure Washer constantly switches on and off, it could be that the high-pressure pump or spray attachment is leaky. In this case, have the machine checked by a servicing dealer.
T
Thomas RossAug 30, 2025
What to do if my Stihl Pressure Washer engine stops?
- J
  Jesse TaylorAug 30, 2025
  If your Stihl Pressure Washer engine stops, it may be due to the motor overheating. Check whether the supply voltage and machine voltage match, and let the motor cool down for at least 5 minutes.
Z
Zachary GarciaSep 2, 2025
What to do if Stihl Washer motor hums but doesn't run?
- M
  Misty VargasSep 2, 2025
  If the Stihl Washer motor hums but doesn't run when switched on, several factors could be at play. First, the mains voltage might be too low or improper, so check the electrical connection, plug, cable, and switch. An extension cord with the wrong cross-section or one that's too long could also be the culprit; use an extension cord with a sufficient cross-section or connect the machine without any extension. Another possibility is that the mains circuit-breaker has been tripped; in that case, switch off the machine, actuate the spray gun, engage the safety catch, and reset the mains circuit-breaker. Finally, ensure that you actuate the spray gun when switching on the machine.
K
Kenneth LoganSep 4, 2025
Why is the pressure fluctuating on my Stihl RE 282 PLUS Washer?
- C
  Catherine FitzgeraldSep 4, 2025
  If you're experiencing pressure fluctuations or drops with your Stihl Washer, several issues could be responsible. Start by checking for a water shortage; ensure the water tap is fully open and comply with the permissible suction lift if you're using suction mode. Also, inspect the high-pressure nozzle in the spray head, the water intake strainer in the pump inflow, and the water filter at the pump intake for any dirt or clogs, and clean them if necessary. If these steps don't resolve the issue, the high-pressure pump may be leaky, or the valves may be defective, requiring professional servicing.
L
Linda WrightSep 7, 2025
What to do if my Stihl RE 282 PLUS Washer motor keeps turning on and off?
- H
  Heather TrujilloSep 7, 2025
  If your Stihl Washer motor is constantly switching on and off, it could be due to a leaky high-pressure pump or spray attachment. In this case, have the machine checked by a servicing dealer.
I
irobinsonSep 9, 2025
How to fix a weak jet on my Stihl Pressure Washer?
- G
  georgepetersonSep 10, 2025
  If your Stihl Pressure Washer has a weak, ragged, or unclean jet, the nozzle may be fouled. Clean the nozzle to resolve this issue.