Stihl RG - Maintenance Details; Maintenance Intervals and Gearbox Lubrication; Blade Handling Procedures

0458-810-0121-A
10
English 13 Maintenance
13.2 Lubricating the Gearbox
► Shut off the powerhead.
► Remove the screw plug (2).
► If no grease can be seen on the end of the screw plug (2):
► Screw the tube (1) of STIHL gear grease into the filler
hole.
► Squeeze 10 g STIHL gear grease into the gear housing.
► Unscrew the tube (1) of STIHL gear grease.
► Refit and tighten down the screw plug (2) firmly.
► Run the powerhead for 1 minute.
STIHL gear grease is distributed evenly.
13.3 Removing and Attaching the Blade
13.3.1 Removing the Blades
WARNING
The cutting edges of the blades are sharp. There is a risk of
cut injuries.
► Wear work gloves made of durable material.
► Shut off the powerhead.
► Remove screw (1) clockwise.
► Remove the rider plate (2).
► Remove screws (3) counterclockwise.
► Remove blade (4).
► Remove screws (5) counterclockwise.
► Remove blade (6).
13.3.2 Mounting the Blades
WARNING
The cutting edges of the blades are sharp. There is a risk of
cut injuries.
► Wear work gloves made of durable material.
► Shut off the powerhead.
► Fit blade (1).
2
1
0000-GXX-8739-A0
2
1
6
4
3
5
0000-GXX-8733-A0
5
6
3
4
1
2
0000-GXX-8734-A0