Need help?Do you have a question about the Stihl FS and is the answer not in the manual?
General| Brand | Stihl |
|---|---|
| Model | FS |
| Category | Garden Machinery Accessories |
| Language | English |
All pictograms attached to the machine are shown and explained.
Warning and Notice symbols are explained for user understanding.
STIHL's philosophy of continuous product improvement is discussed.
Guidelines for appropriate protective clothing and safety equipment.
Checks and preparations required before operating the power tool.
Instructions on how to properly hold and control the machine.
Symbols indicating approved cutting attachment and deflector combinations.
Specifics for the Polycut mowing head equipped with polymer blades.
Warning about the risk of kickback when using certain cutting attachments.
Step-by-step guide for attaching the loop handle with a barrier bar.
Step-by-step guide for attaching the loop handle without a barrier bar.
Steps to prepare the power tool before attaching new equipment.
Instructions on how to safely remove the protective cap from the drive tube.
Procedures for detaching existing gearboxes or attachments.
Steps for fitting the skirt and blade onto the deflector.
Procedure for mounting the limit stop, especially for saw blades.
Instructions on how to safely place the power tool before attachment work.
Details on the hardware needed for mounting cutting tools.
Method to secure the output shaft for attachment mounting/removal.
Guidance on verifying the correct rotation direction for metal cutting attachments.
Instructions on how to use transport guards for cutting attachments.
Specifics for using transport guards with 230mm grass cutting blades.
Specifics for using transport guards with 250mm brush knives.
How to check and maintain the balance of cutting attachments after sharpening.
Instructions on how to safely place the power tool for maintenance.
Steps for replacing the nylon line in the mowing head.
Specifics for adjusting nylon line on the SuperCut model.
Specifics for adjusting nylon line on the AutoCut model.
Specifics for adjusting nylon line on the TrimCut model.
Instructions to check and retighten all accessible screws and nuts.
Guidance on inspecting and maintaining cutting attachments.
Procedures for checking and replenishing gearbox lubrication.
Instructions to replace illegible safety labels.
General guidance on performing regular maintenance tasks.
Identification of parts prone to normal wear and tear.
To Next Page
