To Next PageTo Next Page
Need help?Do you have a question about the Stihl FS-KM and is the answer not in the manual?
Explains symbols shown on the machine and in the manual.
Explains text notation for procedures and illustrations.
Notes on model variations and optional components marked with an asterisk.
STIHL's policy on product changes and updates.
Consolidates critical warnings about hazards, operator responsibility, and bystanders.
Procedures for safely moving the brushcutter.
Steps before starting operation, including adjustments and checks.
Safety guidelines for handling gasoline and fuel mixtures.
Rules for service, warranty, and parts.
Safety precautions during maintenance tasks.
How to maintain and sharpen cutting tools.
Steps for checking and adding grease.
How to use a file for sharpening.
How to balance blades after sharpening.
Advice on using line heads and their features.
Caution against using wire or metal-reinforced line.
Specifics on SuperCut line advancement.
Specifics on TrimCut line advancement.
AutoCut line feed mechanism.
PolyCut head features and wear limits.
How to use grass cutting blades.
How to use the brush knife for various tasks.
Warnings and advice for cutting woody stems.
How to use the circular saw blade safely.
Lists compatible CombiEngine models.
Notes on mounting the barrier bar.
Defines kickout and its causes.
Lists available cutting attachments.
Lists available deflectors.
Lists available handle types.
Lists available harness types.
Lists standard equipment included with the CombiTool.
How to choose correct combinations based on the table.
Critical safety notes for proper tool/handle/harness selection.
Steps to connect the drive tube to the coupling sleeve.
Reverse steps for disconnecting the drive tube.
Identifies deflector types for different cutting tools.
How to attach the deflector to the gearhead.
Steps to fit the skirt and blade to the deflector.
How to position the brushcutter for mounting.
How to install the stop for circular saw blades.
Notes on included mounting hardware.
Directs to section for mowing head installation.
Notes on additional parts for metal tools.
Procedures for attaching cutting tool and harness.
Steps to remove the cutting tool.
How to fit and use a shoulder strap harness.
How to fit and use a full harness.
How to connect the unit to the harness.
Adjusting the unit for proper balance.
Describes correct floating positions for different tools.
How to disconnect the unit from the harness.
General procedure for starting the engine.
Procedure for shutting off the engine.
Instructions for storing for 3 months or longer.
Steps for checking and adding grease.
How to use a file for sharpening.
How to balance blades after sharpening.
General guidelines for maintenance frequency.
Checking and retightening accessible screws.
Visual inspection and replacement of cutting tools.
Weekly check and top-up of gearbox lubricant.
Replacing illegible safety labels.
Lists and illustrates the main components of the CombiTool.
Explains the function of key parts.
Specifies the weight of the unit.
How to get information on available accessories.
What maintenance users can perform.
Where other repair work should be performed.
Conditions for warranty claims after repairs.
How to identify genuine STIHL replacement parts.
Lists STIHL's registered trademarks.
Lists STIHL's common law trademarks.
General
