RMA 370
English
19
The battery is given a charge of about
30% before leaving the factory.
Recommendation: Fully charge the
battery before using your power tool for
the first time.
Fitting the Battery
Open the battery compartment.
N Press in the tab (1) and swing the
cover (2) to the rear.
Fitting the Fuse Key
The motor can be started only when the
fuse key is fitted.
N Push the fuse key (3) into the socket
(4) as far as stop.
Fitting the Battery
N Place the battery (5) in the battery
compartment and push it home.
Closing the Battery Compartment
N Swing the cover (2) down – the tab
(1) must snap into position.
The battery compartment must always
be closed during operation.
Switching On
Do not start the motor in high grass or in
the lowest setting (height of cut) since
this makes starting more difficult.
N Press in the switch lockout button
(1) with your right hand and hold it
there.
N Pull the switch lever (2) against the
handlebar with your left hand and
hold it there – release the lockout
button.
Switching On
To Next Page
Loading...
