RMA 370
English
20
N To switch off the motor, release the
switch lever (1) – the cutting blade
comes to a standstill after coasting
for a few seconds.
Always remove the battery and fuse key
from the power tool during work breaks
and after finishing work.
Coasting Brake
The coasting brake brings the cutting
blade to a standstill in less than 3
seconds after the switch lever is
released.
1 Coasting brake disengaged.
2 Coasting brake stops the rotating
cutting blade.
Removing the Battery
Opening the Battery Compartment
N Press in the tab (1) and swing the
cover (2) to the rear.
Removing the Battery
N Pull the battery (3) out vertically.
Removing the Fuse Key
N Pull the fuse key (4) out of the
socket (5).
Switching Off
To Next Page
Loading...
