–
Data connection: Bluetooth
®
5.1. The
mobile appliance must be compatible with
Bluetooth
®
Low Energy 5.0 and support
Generic Access Profile (GAP).
–
Frequency band: ISM band 2.4 GHz
–
Maximum RF power transmitted: 1 mW
–
Signal range: approx. 10 m. The signal
strength depends on the ambient conditions
and the mobile terminal. Signal range can
vary greatly depending on local conditions,
including the receiver. The range may be
perceptibly reduced inside enclosed rooms
and through metal barriers (such as walls,
shelves or cases).
–
Mobile appliance operating system require‐
ments: Android or iOS (current version or
higher)
22.4 Sound Values and Vibration
Values
RMA 443.2 VC, RMA 443.2 PV
The K value for the sound pressure level is
2 dB(A). The K value for the sound power level is
1.2 dB(A). The K value for the vibration value is
1.10 m/s².
–
Sound pressure level L
pA
measured in accord‐
ance with EN 60335-2-77: 75 dB(A)
–
Guaranteed sound power level L
WAd
meas‐
ured in accordance with 2000/14/
EC / S.I. 2001/1701: 90 dB(A)
–
Vibration value a
hv
measured in accordance
with EN 20643, EN 60335-2-77, handlebar:
2.20 m/s²
RMA 448.2 VC, RMA 448.2 PV
The K value for the sound pressure level is
2 dB(A). The K value for the sound power level is
1.2 dB(A). The K value for the vibration value is
0.9 m/s².
–
Sound pressure level L
pA
measured in accord‐
ance with EN 60335-2-77: 80 dB(A)
–
Guaranteed sound power level L
WAd
meas‐
ured in accordance with 2000/14/
EC / S.I. 2001/1701: 94 dB(A)
–
Vibration value a
hv
measured in accordance
with EN 20643, EN 60335-2-77, handlebar:
1.8 m/s²
The indicated vibration values were measured in
accordance with a standardised test method and
can be used for the purpose of comparing electri‐
cal appliances. The actual vibration values that
occur may deviate from the indicated values,
depending on the type of application. The indica‐
ted vibration values can be used for an initial
assessment of the vibration load. The actual
vibration load must be assessed. Times during
which the electrical appliance is switched off,
along with times during which it is switched on
but running without load, can also be taken into
consideration.
For information on compliance with Employers'
Vibration Directive 2002/44/EC and
S.I. 2005/1093, see www.stihl.com/vib.
22.5 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
23 Spare Parts and Accesso‐
ries
23.1 Spare parts and accessories
These symbols indicate original STIHL
spare parts and original STIHL acces‐
sories.
STIHL recommends the use of original STIHL
spare parts and accessories.
Despite ongoing market observation, STIHL is
unable to judge the reliability, safety and suitabil‐
ity of other manufacturers' spare parts and
accessories; accordingly, STIHL cannot warrant
for the use of those parts.
Original STIHL spare parts and original STIHL
accessories are available from STIHL dealers.
23.2 Essential Spare Parts
–
Blade RMA 443.2 VC, RMA 443.2 PV:
6338 702 0130
–
Blade RMA 448.2 VC, RMA 448.2 PV:
6358 702 0115
–
Blade fastening screw: 9008 319 9028
–
Washer: 0000 702 6600
24 Disposal
24.1 Disposing of the Lawn Mower
Information on disposal is available from your
local authority or from a STIHL dealer.
Improper disposal may be harmful to health and
pollute the environment.
23 Spare Parts and Accessories English
0478-131-9948-D 47
To Next Page
Loading...
Need help?
General
Weight and Dimensions
