Stihl SE 33 - Troubleshooting; Correcting Common Faults

0458-889-8321-A
16
English 15 Troubleshooting
15.1 Correcting faults on the wet/dry vacuum cleaner
15 Troubleshooting
Fault Cause Remedy
The wet/dry vacuum
cleaner does not start
when switched on.
The mains plug of the connecting cable or
extension cord is not plugged in.
► Plug in the plug of the connecting cable.
The circuit breaker (fuse) or the overload cutout
has tripped. There is an electrical overload or a
fault in the circuit.
► Look for cause of tripping and remedy it.
Insert circuit breaker (fuse) or overload
cutout.
► Switch off other loads connected to the same
circuit.
The fuse rating of the socket is too low. ► Plug the connecting cable into a socket with
the correct fuse rating, @ 16.1.
The extension cord has an incorrect cross-
section.
► Use an extension cord with an adequate
cross-section, @ 16.2
The extension cord is too long. ► Use an extension cord with the correct
length, @ 16.2
The wet/dry vacuum
cleaner switches off while
in operation.
The plug of the connecting cable or extension
cord has been pulled out of the socket.
► Insert the plug of the connecting cable or of
the extension cord.
The circuit breaker (fuse) or the overload cutout
has tripped. There is an electrical overload or a
fault in the circuit.
► Look for cause of tripping and remedy it.
Insert circuit breaker (fuse) or overload
cutout.
► Switch off other loads connected to the same
circuit.
The fuse rating of the socket is too low. ► Plug the connecting cable into a socket with
the correct fuse rating, @ 16.1.
The suction power is too
low.
The filter bag or the container is full. ► Replace filter bag or empty the container.
The cartridge filter is dirty. ► Clean or replace the cartridge filter.
The container is full. The float is enabled. ► Empty the container.