•
Thread the rope through the rotor
and secure it with a simple over-
hand knot.
•
Coat rope rotor bearing bore with
non-resinous oil.
•
Slide rotor onto starter post -
turn it back and forth so that anchor
loop of rewind spring engages -
•
Refit the pawls in the rotor -
•
Fit the washer on the starter post
•
Use screwdriver or suitable pliers
to install spring clip on starter
post and over the pawl pegs -
the spring clip must point in
clockwise direction -
see illustration.
5HSODFLQJDEURNHQUHZLQGVSULQJ
•
Lubricate the new spring with a few
drops of non-resinous oil -
•
Remove the rope rotor -
see "Replacing Starter Rope" -
•
Remove parts of old spring.
353BA036 T
To Next Page
Loading...
