Trimmer and Brushcutter Safety Manual
English
4
– Use only an approved combination
of cutting attachment, deflector,
handle and harness. All parts must
be assembled properly and
securely.
– Slide control / stop switch must
move easily to STOP or 0
– Smooth action of throttle trigger
interlock (if fitted) and throttle trigger
– the throttle trigger must return
automatically to the idle position.
– Check that the spark plug boot is
secure – a loose boot may cause
arcing that could ignite combustible
fumes and cause a fire.
– Cutting tool or attachment: Check
for correct and secure assembly
and good condition.
– Check protective devices (e.g.
deflector for cutting tool, rider plate)
for damage or wear. Always replace
damaged parts. Do not operate your
machine with a damaged deflector
or worn rider plate (lettering and
arrows no longer legible).
– Never attempt to modify the controls
or the safety devices in any way.
– Keep the handles dry and clean –
free from oil and dirt – for safe
control of the power tool.
– Adjust the harness and handle(s) to
suit your height and reach. See
chapters on "Fitting the Harness"
and "Balancing the
Trimmer/Brushcutter".
To reduce the risk of personal injury,
do not operate your power tool if it is
damaged or not properly assembled.
If you use a shoulder strap or full
harness: Practise removing and putting
down the machine as you would in an
emergency. To avoid damage, do not
throw the machine to the ground when
practising.
Starting the Engine
Start the engine at least 3 meters from
the fueling spot, outdoors only.
Place the unit on firm ground in an open
area. Make sure you have good balance
and secure footing. Hold the unit
securely. The cutting attachment must
be clear of the ground and all other
obstructions because it may begin to run
when the engine starts.
Your brushcutter is a one-person unit.
To reduce the risk of injury from
thrown objects, do not allow other
persons within a radius of 15 meters of
your own position – even when starting.
Check idle speed setting: The cutting
attachment must not rotate when the
engine is idling with the throttle trigger
released.
To reduce the risk of fire, keep hot
exhaust gases and hot muffler away
from easily combustible materials (e.g.
wood chips, bark, dry grass, fuel).
Holding and Controlling the Unit
Always hold the unit firmly with both
hands on the handles.
Make sure you always have good
balance and secure footing.
Models with bike handle
Right handle on control handle, left hand
on left handle.
To reduce the risk of
injury, avoid contact with
the cutting attachment.
Do not drop start the
power tool – start the
engine as described in
the instruction manual.
Note that the cutting
attachment continues to
run for a short period
after you let go of the
throttle trigger – fly-
wheel effect.
002BA055 KN
To Next Page
Loading...
