4/4
6. Mechanical Reset
7. The default lowest height is 72cm.
If you want to adjust lowest position to 67cm please follow below step.
1. Press " " button for 3-4 second until it shows "S - - " and flash.
2. Press " " button 1 time to go into the menu showing "Un".
3. Press "down" arrow button 4 times until it shows "SH".
4. Press " " button again the screen will now show "0".
5. Press "down" button again until it shows "L".
6. Press "down" button again until it shows "072".
7. Press "down" button until it shows "067" .
8. Press " " button 1 time to confirm the lowest position.
9. Press "down" button until desk to "067" .
1. Power the desk off.
2. Check and confirm the connections between motor and controller are correct as per assembly instructions.
3. Power the desk on.
4. Press " " button for 3-4 second until it shows "S - - " and is flashing.
5. Press " " button 1 time to go into the menu showing "Un".
6. Press up arrow button 2 times until it shows "rS ".
7. Press " " button again the screen will now show "OFF".
8. Press up arrow button until it shows "ON".
9. Press " " button again and "ON" will stop flashing.
10. Hold the down arrow button for the desk to move down until it shows "072".
UNEVEN LEGS: If the issue is that the legs are uneven, the higher leg should come down first until it is at the same height
11. Hold the down arrow button again until the screen shows "rES". Desk will automatic go down until it reaches to
12. You can use the up and down arrow to adjust your desk height as per normal.
the lowest position "067".
as the lower leg. Then screen will now show "E20" then show current height of desk. If you press "down" arrow and the desk
still will not move, please try to hold down the " " button for 3-4 second until the desk goes down to it's programmed lowest
position of "072".
To Previous Page
Loading...
