Stiltz Duo+ - Additional Safety Sensors Explained; Emergency Stop and Alarm Functionality

Addional Safety Sensors
Balance sensors will stop the li car if a
problem exists with either of the li ropes.
Overload sensors will determine whether
the li is overloaded prior to moving. To
nofy the user that the li is overloaded,
the related area on the car operang panel
(COP) inside the cabin will ash. (See p6).
The Slack Rope sensor detects if the li
ropes are slack and will prevent the li car
from aempng to travel any further.
In the unlikely event that the regular limit
switches should fail, there are auxiliary
switches located above and beneath the li
car. If these should fail at the same me,
there are further back up switches that will
stop the li in an emergency. Once these
emergency stops are acvated, the li will
stop unl the incident has been invesgated
by a service technician, and the problem has
been corrected.
Emergency Features
The li is equipped with an emergency stop
buon. Pressing the red emergency stop
buon whilst travelling in the li will stop
the li immediately and trigger the alarm.
Therefore, this buon should only be used
in extreme situaons; such as the li failing
to stop when the control buon is released.
To nofy the user that the emergency stop
has been acvated, the related area on the
car operang panel (COP) inside the cabin
will ash (See p6).
The emergency system must be reset once
the cause of the incident has been resolved.
8