STINGER ELECTRONICS (PTY) LTD BS120 INSTRUCTION MANUAL REF:03/2018
Printed: 4/26/2019 Page 10 of 20
THE FOLLOWING FAULTS CAN BE DISPLAYED:
The system is in the HIGH voltage mode and has detected that the live wire has been cut,
resulting in an open circuit indication. Pressing “reset” will silence the built-in buzzer, but the
problem needs to be resolved first before the screen will return to normal.
The system is in the LOW voltage mode and has detected that the live wire has been cut,
resulting in an open circuit indication. Pressing “reset” will silence the built-in buzzer, but the
problem needs to be resolved first before the screen will return to normal.
The systemis in the HIGH voltage mode and has detected that the livewire is touching a ground
wire in zone 2, resulting in a short circuit indication. Pressing “reset” will silence the built-in
buzzer, but the problem needs to be resolved first before the screen will return to normal.
The systemis in the LOW voltage mode and has detected that thelivewire is touching a ground
wire in zone 2, resulting in a short circuit indication. Pressing “reset” will silence the built-in
buzzer, but the problem needs to be resolved first before the screen will return to normal.
The system has detected that it is not possible to communicate with unit 1. Pressing “reset” will
silence the built-in buzzer, but the problem needs to be resolved first before the screen will
return to normal.
Mains Failure detection for unit 1. Theenergizer is now running from the battery for a limited
period of time.
2007/01/01 0:00:17
UNIT1 H 20 ZONES
! Open Circuit !
(RESET) (MENU)
2007/01/01 0:00:17
UNIT1 L 20 ZONES
! Open Circuit !
(RESET) (MENU)
2007/01/01 0:00:17
UNIT1 H ZONE 2
!Short Circuit !
(RESET) (MENU)
2007/01/01 0:00:17
UNIT1 L Zone 2
! Short Circuit !
(RESET) (MENU)
2007/01/01 0:00:17
UNIT1 !!!
No communication
(RESET) (MENU)
2007/01/01 0:00:17
UNIT1 H 20 Zones
! Mains Failure !
(RESET) (MENU)
2007/01/01 0:00:17
UNIT1 H 20 Zones
! BatteryLow !
(RESET) (MENU)
To Next Page
Loading...