TROUBLE SHOOTING
PROBLEM
1. Tool operates, but no fasteners are driven
2. Cap leaks air
3. Fasteners jam in nose of tool
4. Weak drive
5. Skipping fasteners
6. Fasteners will not drive completely into
work piece
CORRECTION
Check Magazine for proper fasteners.
Fasteners should slide freely in and out of
the magazine
Tighten cap screws
• Remove fasteners from Magazine
• Open Quick Clear™ Lever, remove jammed
fastener and close Latch.
• Load tool
Check to make sure there is adequate air
supply
• Replace Bumper if worn
• Use only recommended fastener size
• Replace Magazine if worn
• Check air supply as it may be too low or
too high
• Adjust the depth of drive
• Check air supply as it may be too low or
too high
• Inspect driver blade for damage
DISCONNECT THE AIR HOSE FROM THE TOOL WHEN
PERFORMING INSPECTIONS, MAINTENANCE, OR REPAIRS.
Please contact Inside Sales for technical support if you have any other problems
800 - 746 - 5659
12
To Next Page
Loading...
