EasyManua.ls Logo

Stirling SFLW75 - Cleaning and Maintenance; Cleaning Procedures; Cleaning the Exterior; Cleaning the Drum

Stirling SFLW75
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1716
MODEL: SFLW75 | PRODUCT CODE: 701331 | 07/2020MODEL: SFLW75 | PRODUCT CODE: 701331 | 07/2020
Cleaning and Maintenance
CLEANING PROCEDURES
WARNING!
Before beginning any cleaning or maintenance, always
ensure the appliance is switched o, the power plug is
removed from the power outlet and the water supply
has been closed.
CLEANING THE WASHING MACHINE
Proper maintenance of your washing machine will keep
it looking as new and extend its working life.
The exterior surface can be cleaned with household
cleaners and a soft damp cleaning cloth.
If there is any residual water at the completion of a
washing program, please use a cloth to wipe it o
immediately.
Note: Never use solvents or harsh cleaning chemicals
on your washing machine’s exterior.
CLEANING THE INTERNAL DRUM
Should any rust form on the inside drum (i.e. water was
left to sit for an extended period of time), please remove
immediately using a chlorine free detergent. Never use
steel wool or a harsh abrasive.
FROZEN WASHING MACHINE
Should the temperature drop below zero and your
washing machine becomes frozen, you should:
Disconnect the power supply for the washing
machine.
Wash the tap connection with warm water, to help
you to disconnect the inlet pipe.
Remove the inlet pipe and immerse in warm water
(i.e. within a bathtub).
Pour some warm water into the washing machine
drum and wait for approximately 10 minutes.
Reconnect the inlet pipe to the tap and washing
machine and open the water supply.
Wait until the room’s ambient temperature returns
to above 0°C before trying to operate the washing
machine.
CLEANING THE DOOR SEAL AND GLASS
Wipe the glass and seal after each wash to remove lint
and stains. If lint builds up it can cause leaks.
Remove any coins, buttons and other objects from the
seal after each wash.
CLEANING THE DETERGENT DRAWER
You should periodically follow these steps to ensure the
detergent drawer remains clean:
Do not use alcohol, solvents or chemical products
to clean the machine.
Press down on the arrow, located on the cover for
the fabric softener compartment of the detergent
drawer.
Lift the clip up and remove the fabric softener
compartment cover.
Wash all grooves with warm water.
Re-install the fabric softener compartment cover
into the detergent drawer, and push the drawer back
into position.
CLEANING THE INLET FILTER
You should clean the inlet lter periodically, or if you nd
that insucient water is being supplied to your washing
machine when the supply tap is open.
Washing the lter in the tap
Close the water supply tap.
Remove the water supply hose from the tap.
Clean the lter
Reconnect the water supply hose.
To clean the washing machine lter:
Screw o the inlet pipe from the rear of the
washing machine.
Pull out the lter with long nose pliers, wash it
thoroughly with water and re-install the lter.
Reconnect the inlet pipe to the rear of the
washing machine.
Open the water supply at the tap and ensure there
is no water leakage.
Once nished, close the water supply tap.
Note: If the brush is not clean, you can pull out the lter
washed separately; Reconnect, turn on the tap.
CLEANING THE DRAIN PUMP FILTER
Removing foreign objects
WARNING!
To avoid the risk of an electric shock, always remove
the power plug from the power outlet before cleaning
the Drain Pump lter.
Periodically you should clean the drain pump lter to
ensure normal operation of your washing machine.
The type of washing, frequency and soil level of your
washing cycles will alter how often this procedure
needs to be undertaken, however you should inspect
the lter regularly.
Should your washing machine not empty and/or spin, or
your machine makes unusual noises during operation,
your Drain Pump lter could be blocked. Follow this
procedure to check or remove any foreign objects.
After disconnecting the power, open the lter cover
at the front base of your washing machine.
Unscrew the lter in an anti-clockwise direction and
remove any foreign objects.
Re-install the lter and close the service panel.
WARNING!
Never remove the pump cover when the washing
machine is in operation, always wait until the appliance
has nished and the is empty. There can be hot water
within the pump, so be careful to avoid burns, should
it have operated recently. When replacing the cover, be
careful to ensure it is closed securely.
Washing the filter in the tap
1.Close the tap.
2.Remove the water supply hose from the tap.
3.clean the filter.
4.Reconnect the .water supply hose
Cleaning The Inlet Filter
Inlet filter must be cleaned if there is less water.
If the brush is not clean, you can pull out the filter washed separately;
Reconnect, turn on the tap.
Washing the filter in washing machine:
1.
Screw off the inlet pipe from the backside
of the machine.
2.Pull out the filter with long nose pliers
and reinstall it back after being washed.
3.Use to clean the filter.
4.Reconnect the inlet pipe.
the brush
Clean The Detergent Dispenser
Do not use alcohol,solvents or chemical products to clean the machine.
A
Pull out the dispenser
drawer with press the A
Clean the dispenser
drawer under water
Clean inside the recess
with an old toothbrush
Insert the dispenser
drawer
1
2
3
4
Note!
Note!
Note!
23
1.Press down the arrow location on softener cover inside the dispenser drawer.
2.Lift the clip up and take out softener cover and wash all grooves with water.
3.Restore the softener cover and push the drawer into position.
MAINTENANCES
Washing the filter in the tap
1.Close the tap.
2.Remove the water supply hose from the tap.
3.clean the filter.
4.Reconnect the .water supply hose
Cleaning The Inlet Filter
Inlet filter must be cleaned if there is less water.
If the brush is not clean, you can pull out the filter washed separately;
Reconnect, turn on the tap.
Washing the filter in washing machine:
1.
Screw off the inlet pipe from the backside
of the machine.
2.Pull out the filter with long nose pliers
and reinstall it back after being washed.
3.Use to clean the filter.
4.Reconnect the inlet pipe.
the brush
Clean The Detergent Dispenser
Do not use alcohol,solvents or chemical products to clean the machine.
A
Pull out the dispenser
drawer with press the A
Clean the dispenser
drawer under water
Clean inside the recess
with an old toothbrush
Insert the dispenser
drawer
1
2
3
4
Note!
Note!
Note!
23
1.Press down the arrow location on softener cover inside the dispenser drawer.
2.Lift the clip up and take out softener cover and wash all grooves with water.
3.Restore the softener cover and push the drawer into position.
MAINTENANCES
Cleaning and Maintenance (Cont.)
Washing the filter in the tap
1.Close the tap.
2.Remove the water supply hose from the tap.
3.clean the filter.
4.Reconnect the .water supply hose
Cleaning The Inlet Filter
Inlet filter must be cleaned if there is less water.
If the brush is not clean, you can pull out the filter washed separately;
Reconnect, turn on the tap.
Washing the filter in washing machine:
1.
Screw off the inlet pipe from the backside
of the machine.
2.Pull out the filter with long nose pliers
and reinstall it back after being washed.
3.Use to clean the filter.
4.Reconnect the inlet pipe.
the brush
Clean The Detergent Dispenser
Do not use alcohol,solvents or chemical products to clean the machine.
A
Pull out the dispenser
drawer with press the A
Clean the dispenser
drawer under water
Clean inside the recess
with an old toothbrush
Insert the dispenser
drawer
1
2
3
4
Note!
Note!
Note!
23
1.Press down the arrow location on softener cover inside the dispenser drawer.
2.Lift the clip up and take out softener cover and wash all grooves with water.
3.Restore the softener cover and push the drawer into position.
MAINTENANCES
Before your maintenance starts, please unplug the machine and close the tap.
Cleaning The Cabinet
Cleaning The Drum
Formic acid and its diluted solvents or equivalent are forbidden, such as
solvents or chemical products,etc.
alcohol,
Dont put laundry in the washing machine during the drum cleaning.
Cleaning The Door Seal And Glass
Warning!
Note!
Note!
10
22
Cleaning And Care
The rusts left inside the drum by the metal articles shall be removed immediately
with chlorine-free detergents.
Never use steel wool.
Proper maintenance on the washing machine can extend its
working life. The surface can be cleaned with diluted
non-abrasive neutral detergents when necessary. If there is
any water overflow, use the wet cloth to wipe it off immediately.
No sharp items are allowed.
Wipe the glass and seal after each wash
to remove lint and stains. If lint builds up it
can cause leaks.
Remove any coins, buttons an
d other objects
from the seal after each wash.
MAINTENANCES
Make sure that valve cap and emergency drain hose are reinstalled properly, cap
plates should be inserted aligning to hole plates otherwise water may leak;
Some machines dont have emergency drain hose, Rotate lower cover cap directly
to make water run into basin.
When the appliance is in use and depending on the programme selected there can
be hot water in the pump. Never remove the pump cover during a wash cycle, always
wait until the appliance has finished the cycle, and is emp
ty. When replacing the
cover, ensure it is securely re-tightened.
Cleaning The Drain Pump Filter
Be careful of the hot water!
Allow detergent solution to cool down.
Unplug the machine to avoid electrical shock before washing.
Drain pump filter can filter the yarns and small foreign matters from the
washing.
Clean the filter periodically to ensure the normal operation of washing
machine.
Warning!
10
24
Caution!
MAINTENANCES
Open the Service filter
Open the filter by turning
to the counter clockwise
Remove extraneous
matter
1
Close the lower cover cap
3
2
4
Make sure that valve cap and emergency drain hose are reinstalled properly, cap
plates should be inserted aligning to hole plates otherwise water may leak;
Some machines dont have emergency drain hose, Rotate lower cover cap directly
to make water run into basin.
When the appliance is in use and depending on the programme selected there can
be hot water in the pump. Never remove the pump cover during a wash cycle, always
wait until the appliance has finished the cycle, and is emp
ty. When replacing the
cover, ensure it is securely re-tightened.
Cleaning The Drain Pump Filter
Be careful of the hot water!
Allow detergent solution to cool down.
Unplug the machine to avoid electrical shock before washing.
Drain pump filter can filter the yarns and small foreign matters from the
washing.
Clean the filter periodically to ensure the normal operation of washing
machine.
Warning!
10
24
Caution!
MAINTENANCES
Open the Service filter
Open the filter by turning
to the counter clockwise
Remove extraneous
matter
1
Close the lower cover cap
3
2
4

Related product manuals