FAQ
Error messages
When the following problems occur, the microcomputer inside the washer will detect the errors. An
electronic buzzer will sound for approximately 10 seconds, an error message will ash, as shown below,
and the washer will stop operating.
Problem Error Possible Diagnosis Possible Solutions
Washer not lling with water E1 • Inlet taps not turned on
• Blocked inlet hose lters
• ‘Delay Start’ is set
• Check that both the hot
and coldtaps are turned on
• Clear blockages from inlet
hose lters
• Refer to page 19 for
information about the
‘Delay Start’ function
Water is not draining E2 • Drain hose is not properly
connect or installed
• Drain hose is kinked or
obstructed
• Drain hose is clogged
• Drain pump lint lter at the
lower rear of the machine
is clogged
• Check the drain hose
connection as per page 11
• Check the drain hose
connection as per page 11
• Disconnect hose and check
for obstructions
• Clear drain pump lint lter
as per page 23
Washer will not start E3 • Lid is not closed properly • Check that the lid is closed
Washer does not spin E4 • The load could be out
of balance
• Pause washer and manually
redistribute the load
• Check the washer is level
and does not rock in any
direction. Refer to page 13
• Check the washer does not
have suds build up
To Next Page
Loading...
