Care and Cleaning Cont.
Drain pump maintenance
We recommend that you clean the drain pump lter regularly (at least once a month) to avoid blockages
created by bobby pins, coins and excess lint.
Proceed as follows:
1. Disconnect the washer from the power source.
2. If necessary, wait until the water has cooled down.
3. Place a container underneath the pump opening to collect any spillage (see below, left).
4. Turn the lter cap anticlockwise to take it out gently (see below, right). Always keep a rag nearby to dry up
water spillage when removing the pump lter.
5. To remove any objects from the lter, wash it thoroughly in a basin or under running water (see below,
left).
6. Put the cap back and place the lter back in its seat (see below, right).
Note: The drain pump is located at the rear of the machine as illustrated on Fig. 3, page 11.
To Next Page
Loading...
