Installing the dishwasher
Let’s get your new stainless steel
dishwasher ready to use!
Quick Start Guide
Model: STR-DWSS14
Customising your
dishwasher
4
B
CAUTION! This dishwasher is heavy – ensure you have a helper to move it.
This dishwasher should be professionally installed by a licensed plumber or dishwasher
installer. Do not install it yourself.
WHERE TO INSTALL? This dishwasher is designed for freestanding use, but it can also be recessed
under a single benchtop. The back should rest against the wall behind it and the sides along any
adjacent cabinets or walls. Position the dishwasher on a level and sturdy floor. If the floor is uneven,
adjust the feet until it reaches a horizontal position.
WATER AND POWER CONNECTIONS Have the appliance installed close to an existing water
inlet and drain connection and make sure there is power point nearby, or in an adjoining cabinet.
The dishwasher’s water supply and drain hoses can be positioned either to the right or left sides to
facilitate proper installation. Only use the supplied new hoses when connecting this dishwasher to the
water supply.
Please refer to pages 12–15 in the manual for comprehensive installation instructions.
A
The height of the upper basket can easily be
adjusted in the upper or lower position in order
to accommodate taller dishes.
If you need more space for pots and pans in the
lower basket, you can fold down the spike rows
at the back so that larger or more pots and
pans can be loaded.
The cup rack is designed to hold smaller cups or
similar lightweight items. To make room for taller
items in the upper basket, you can raise it upwards,
or remove it when it is not required for use.
Cutlery may be washed in either the sliding cutlery
rack (in the upper basket) or cutlery basket
(in the lower basket).
Upper position
Lower position
1
1
2
3
Folded backwards
Raised upwards
Sliding cutlery tray
Cutlery basket
Nearly done! Just a bit more on the
other side of this page...
2
3
4
To Next Page
Need help?
General
