Stiroplus SP1045 - User Manual

Questions and Answers

J
Jennifer PetersAug 5, 2025
Why is dirty water coming out of my Stiroplus SP1045 Iron?
- M
  Morgan AllenAug 5, 2025
  If dirty water or mineral deposits are coming out of the soleplate of your Stiroplus Iron, or if the soleplate is dirty, it's likely due to calcium particles and minerals in the water depositing in the steam holes or inside the appliance. Clean the soleplate with a damp cloth. You should also descale the appliance by following the instructions in the “CLEANING AND MAINTENANCE” section.
N
Natasha PriceAug 10, 2025
What to do if my Stiroplus SP1045 Iron is not producing steam?
- A
  Alison OrtegaAug 10, 2025
  If your Stiroplus Iron is not producing steam, there could be several reasons. First, ensure that the water tank has enough water. If not, fill it. Second, the iron may not be hot enough; wait until the temperature indicator light goes off and the steam rate indicator stops flashing. Third, check that the water tank is correctly positioned. Finally, make sure the appliance is switched on by connecting the plug to the wall outlet and pressing the power switch.
D
Derrick ButlerAug 16, 2025
Why is my Stiroplus SP1045 Iron leaking water?
- J
  Joanne LeAug 16, 2025
  If water drops are coming out of the soleplate of your Stiroplus Iron, it might be because you're using steam at the second temperature setting or lower. When steam ironing, make sure to turn the temperature dial to within the steam section, as shown in the TEMPERATURE DIAL section.
S
Shannon RiveraAug 23, 2025
Why does my Stiroplus SP1045 make a pumping sound?
- K
  Kyle PetersonAug 23, 2025
  The pumping sound from your Stiroplus Iron indicates that water is being pumped into the boiler. If the pumping sound doesn't stop, switch off the appliance, remove the plug from the wall socket, and contact an authorized service center.
A
Andrew DawsonAug 28, 2025
How to turn on Stiroplus Iron?
- M
  Molly JenkinsAug 28, 2025
  To turn on the Stiroplus Iron, press down the power switch until the power indicator light turns on.