Stiroplus SP2020 - User Manual

Questions and Answers

J
John SmithAug 11, 2025
Why is my Stiroplus Iron not producing steam?
- N
  Nicole HarrisAug 11, 2025
  Several factors could be preventing your Stiroplus Iron from producing steam. First, ensure the water tank has enough water. If the water level is sufficient, wait until the temperature indicator light goes off, signaling that the iron is hot enough. Also, make sure the water tank is correctly positioned. Finally, verify that the iron is plugged in and switched on. If the standby time exceeds 10 minutes, press the power switch to turn it on.
C
Carl ConnerAug 17, 2025
How to clean dirty water and mineral deposits from Stiroplus Iron soleplate?
- J
  Joseph BradyAug 17, 2025
  If you notice dirty water or mineral deposits coming from the soleplate of your Stiroplus Iron, it's likely due to calcium particles and minerals in the water accumulating in the steam holes or inside the appliance. To resolve this, clean the soleplate with a damp cloth. You can also descale the appliance.
J
James McintoshAug 23, 2025
What to do if my Stiroplus Iron switches off automatically?
- T
  Travis YangAug 25, 2025
  Your Stiroplus Iron is designed to switch off automatically after 10 minutes if no steam is released from the soleplate. To resume operation, press the power switch to turn it back on; the power indicator should light up.
K
Kathy PerezAug 29, 2025
Why does my Stiroplus Iron make a pumping sound?
- J
  James HaysAug 30, 2025
  The pumping sound from your Stiroplus Iron indicates that water is being pumped into the boiler. If the water tank is empty or not correctly positioned, this sound may persist. Fill the water tank or reposition it properly. If the sound continues, switch off the appliance, remove the plug from the wall socket and contact an authorized service center.
S
Sara HayesSep 4, 2025
What to do if water drops come out of the Stiroplus Iron soleplate?
- B
  Benjamin TuckerSep 4, 2025
  If water drops are coming from the soleplate of your Stiroplus Iron, especially when using the Intellitemp setting, it might be because the iron hasn't finished pre-heating. Ensure the temperature indicator light has gone off, signaling that the soleplate has reached the correct temperature.