The appliance has
switched off
The appliance will turn off
automatically after 10
minutes if no steam spray out
from the soleplate.
Press down the power switch,
the power indicator turns on.
Dirty water and mineral
deposits come
out of the
soleplate or the
soleplate is dirty.
Calcium particles and minerals
present
in the water have deposited in
the steam holes and/or inside
the
appliance.
Use a damp cloth to clean the
soleplate.
Descale the appliance by
following the operation
in paragraph “CLEANING AND
MAINTENANCE”.
The appliance
does not produce
steam.
There is not enough water in
the water tank.
Fill the water tank with water.
The appliance is not hot
enough to produce steam.
Wait until the temperature
indicator extinguish and the
indicator of the defaulted
steam rate changes from
flashing to illuminating.
The water tank is not placed
correctly.
Reposition the water tank
properly.
The appliance is not switched
on.
Connect the plug to wall
outlet and press down the
power switch.
The appliances standby time
exceed 10 minutes
Press down the power switch,
the power indicator turns on.
The appliance
produces a
pumping sound
Τhe sound tells you that water
is pumped into the boiler. If
there’s no water in the water
tank and/or if water tank is
positioned improperly, the
pumping sound will continue
for 2.5minutes, and then
water short indicator will light
.
Fill water into tank or
reposition the water tank
properly.
If the pumping sound does
not stop,
switch off the appliance and
remove the
plug from the wall socket.
Contact the authorized service
center.
Water drops come out of the
soleplate
There may be dripping water
during spraying steam when
the temperature is set
at Intellitemp setting and did
not finish pre-heating.
Make sure the temperature
indicator extinguishes
indicating the soleplate
temperature is adequate.
To Next Page
Loading...
