USING YOUR STEAM STATION
The appliance has two ironing ways. You can use dry ironing or steam ironing, the details
refer to the following.
Dry ironing
1. Put the iron on the thermal insulation stand of unit base.
2. Connect the plug to wall outlet, one beep can be heard, then turn the temperature dial to
select your desired temperature setting, which is depended on the fabric of garment. Refer
to “IRONING TIPS” and “ADDITIONAL TABLE” as below when select temperature.
3. Press the ON/OFF button, the power indicator illuminates, the temperature indicator and
ECO steam rate indicator illuminate, then the iron starts heating.
4. When the temperature of soleplate reaches the selected temperature, the temperature
indicator turns off, and you can start ironing now. Refer to “IRONING TIPS” and
“ADDITIONAL TABLE” as below when ironing.
WARNING: Never touch hot soleplate at any time before cooling down!
Steam ironing
The machine works with normal tap water. In case of very hard water (hardness above
27ºF) we suggest using 50% distilled water diluted with tap water. Alternatively, we
suggest using normal bottled drinking water. The use of de-ionized water is not
recommended.
1. Put the unit base on a stable and level surface.
2. Remove the water tank and fill it with water through the filling aperture. The max capacity
of water tank is 1.7L, the water level shall not be exceeded the MAX mark.
3. Put the iron on the thermal insulation stand of unit base.
4. Connect the plug to wall outlet, one beep can be heard, then turn the temperature dial to
select your desired temperature setting. Refer to “IRONING TIPS” and “ADDITIONAL TABLE”
as below when select temperature.
5. Press the ON/OFF button, the power indicator illuminates, the temperature indicator and
ECO steam rate indicator illuminate. The default setting is the ECO steam rate when the
appliance is turned on.
6. And you can select the desired steam rate for each garment according to your requirement.
There are two modes including MAX and ECO steam rates available. Make sure that there is
enough water in the tank.
7. The iron starts heating, after a few minutes, the temperature indicator extinguishes, it
indicates the soleplate temperature has achieved the selected temperature.
8. When the indicator of selected steam rate lights solidly, it indicates that the iron is ready
for ironing garment with steam. Refer to “IRONING TIPS” and “ADDITIONAL
TABLE” as below when ironing.
9. Press the steam trigger with a little force, the steam will be sprayed from the soleplate
continuously, and then you can iron the garment with steam.
NOTE: There may be dripping water during spraying steam when the temperature is lower
than that of the second setting. This is normal.
CAUTIONS:
To Next Page
Loading...
