STM SatLink 1910 - Restoring the Backup Software

SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 76 (160)
Example:
# sw mcast 1 511 224.0.1.59 2001
#
The above configuration will enable automatic reception of software upgrades on PID 511, IP address
224.0.1.59 and UDP port number 2001.
16.2 Manual Software Update
Users with minimum privilege level 2 may use the CLI command sw upgrade to download a new
software image from the default TFTP server. After successful download of a new software image, the
previous software version will be stored as a backup version before enabling the new software.
Below is described in detail how to upgrade the STM SatLink VSAT software:
1. Verify the default settings for the manual software upgrade with the CLI command
sw show
2. If necessary, update the default settings for the manual software update by using the CLI command
sw upgrade –default <upgraded-SW-filename> <tftp-ip-address>
3. Verify the settings with the CLI command
sw show
4. Execute the SW upgrade by typing
sw upgrade, then restart the STM SatLink VSAT
Example:
#
SW versions:
Boot : 9.0.1.7
Current : 13.0.2.65
Backup : 13.0.2.61
Manual SW upgrade settings:
TFTP server IP addr : 10.10.1.1
File name : new.tgz
Automatic SW upgrade settings:
Activated : Yes
PID : 1022
IP address : 224.0.1.59
Port No. : 2001
Licenses for SW options:
NAT
GRE
PEP-TCP
QOS-4
PEP-HTTP
VLAN
#
# sw upgrade dvb-rcs-12.0.2.39.tgz 10.10.10.8
# sw upgrade
Software download in progress, please wait...................................
...........................................................................
File Transfer complete
Configuration Saved
The VSAT then reboots automatically.