Digital Water Timer
Art. 25027
watering days. The WATERING DAYS are now set and
program proceeding further to set Prog. ON/OFF.
9. Set the Prog. ON/OFF
When the procedures from (1) to (8) are all set properly,
the ‘ON’ will be blinking. Press button Zone 1 or Zone 2
to select ‘ON’ or ‘OFF’. If you select ‘ON’, which means
executing all settings right away or ‘OFF’ which means
reserving all settings without execution and then press
button Item to save whole the program for Zone 1.
10. Set the program for ZONE 2
The reading “12” of ZONE 2 starts flashing. Repeat the
above steps from (1) to (9) to set easily the program
of ZONE 2. Finally, press button Menu/O.K. to confirm
all set up programs for ZONE 1 and ZONE 2. Now, all
setting values on the display screen will flash one time
to signal whole setting procedure is confirmed and all
set values are shown on the screen.
11. Situation in which setting is interrupted:
At any mode, the program will leave setting procedure
and give up setting when setting action is inactive
beyond 3 minutes.
*In case of FIRST TIME setting, the program will leave
the mode setting and show the status of (1), in which
To Next Page
Loading...