How to fix a STODDART Washer that won't start?
If your STODDART Washer isn't starting, first check that the main water supply is properly connected, open, and free of obstructions. Next, ensure the main electrical supply is working correctly. Finally, confirm that the door is completely closed.
Why is my STODDART Washer not cleaning dishes properly?
If your STODDART Washer isn't washing dishes well, check the following: * Ensure the filter trap is clean. * Make sure the washing water jets on the wash arms are not blocked. * Verify you're using the correct amount and quality of detergent and rinse aid. * Try using a longer washing cycle or repeating the current cycle.
What to do if there is excessive foam in the STODDART Washer tank?
If you notice excessive foam in the tank of your STODDART Washer, make sure the washing water temperature is at least 50°C. Also, verify that the tank hasn't been cleaned with unsuitable cleaners; if it has, drain and rinse it thoroughly. If foaming detergent was used, drain and refill the tank with water until the foam disappears.
General| Brand | STODDART |
|---|---|
| Model | Culinaire EVO40ST |
| Category | Dishwasher |
| Language | English |
Welcome to your new Culinaire product and its expected service life.
Instructions on how to register your new product to activate the warranty.
General overview of the product, noting configuration variations by model.
Important advice for safe installation, operation, and maintenance.
Safety precautions and intended use guidelines for the appliance.
Specifies that only qualified technicians should perform repairs and maintenance.
Guidance on handling, unpacking, and positioning the appliance correctly.
Instructions for environmentally responsible disposal of the appliance.
Safety and technical requirements for connecting the unit to the power supply.
Details on connecting water supply, drainage, and pressure requirements.
Procedure for connecting and adjusting the detergent dispenser.
Procedure for connecting and adjusting the rinse aid dispenser.
Comprehensive table detailing model, dimensions, pressure, flow, and electrical specs.
Step-by-step guide for powering on the unit and initial filling.
Instructions on selecting and starting the different wash cycles available.
Process for draining the unit, including filter access and water removal.
General cleaning guidelines, including fastener checks and safety warnings.
Advice on maintaining stainless steel and treating minor rust or corrosion.
Instructions for drying and protecting the unit's stainless steel surface finish.
Daily and end-of-day cleaning requirements for maintaining efficiency.
List of cleaning supplies and PPE needed for maintenance.
Procedure for removing and cleaning the wash pump filter trap.
Method for cleaning the exterior of the unit, avoiding electronics.
Table of common problems and their remedies for unit operation.
To Next Page
