- 17 -
MAINTENANCE SCHEDULE
125CM
A. ENGINE - Daily check the oil
levels in the engine and engine
reduction unit. The engine
warranty is VOID if run without
oil . Since there are many
options available on this mixer,
consult the ENGINE MANUAL
for specific recommendations as
to oil level, oil type required and
frequency of oil changes
required. For maximum service
life from the engine, follow those
recommendations.
B. * WEEKLY - Grease idler shaft
pillow block bearings on electric
drive models.
C. WEEKLY - Lubricate chain and
sprockets on chain drive models
with a few drips of SAE 30
motor oil or any spray chain
lube.
D. MONTHLY - Grease trunnions
(2) places and drum spindle (2)
places.
E. YEARLY - Repack (4) tapered
roller bearings in wheel hubs
and replace wheel seals. Install
washer and nut. Torque to 20
ft. lbs. back off one turn, torque
to 7 ft. lbs. back off to first slot
in nut and insert cotter key.
F. DO NOT lubricate pinion and
ring gear. They will collect
abrasive materials and
accelerate wear.
NOTE: Cowl removed for clarity.
Do not operate mixer with cowl
removed.
Lubricate diesel gearbox with
SAE30W oil as needed.
Use any Grade #1 lithium base
grease for the above applications.
* See Exploded Views in Service/
Parts Manual for exact location.
To Next Page
Loading...
