Store It Cold CoolBot PRO Manual

1 | P a g e
CoolBot Pro Quick Start Set Up Guide Rev 2019 – 03A ©2019 Store It Cold, LLC
Qty
Item
Description
1
CoolBot Pro
Patented Digital Temperature Controller
1
CoolBot Jumper
Wi-Fi Radio Signal Module
2
Temperature Sensors
Sensor Cables (Blue Cable - Black Tip) with external 2.5mm jack connector
1
Heater
CoolBot Heater Cable (Black Cable - Red Tip) with external 2.5mm jack connector
1
Data Cable
Data Transfer Cable (Silver or Grey) with RJ11 connector on both ends
1
Power Supply
Mini-USB port connector cable. Input: 110V-240V / Output: 5V, 1Amp
BEFORE STARTING
•
Should I read this guide? Yes! We highly recommend reading this “Step by Step” guide entirely to ensure proper installation.
We also encourage you to visit our support page
www.storeitcold.com/support and read the detailed CoolBot Pro Manual.
•
What if I don’t have Internet OR Wi-Fi? No problem! You can still use the CoolBot Pro without the CoolBot Jumper and without
a Wi-Fi connection just like the previous generation CoolBots. Go straight to the “INSTALLING YOUR COOLBOT PRO TO YOUR
A/C” Section of this Guide (page 3). NOTE: Your CoolBot Pro will keep your cooler cold but you won’t be able to access online
data or change settings from the CoolBot Pro App.
• I have an Internet connection AND Wi-Fi. Awesome! Then you will enjoy all of the benefits the CoolBot Pro and its app. Start
with the “CONNECTING YOUR COOLBOT PRO TO YOUR WI-FI NETWORK” Section of this Guide (page 2), and then move to the
“INSTALLING YOUR COOLBOT PRO TO YOUR A/C” Section of this Guide (page 3).
•
I am replacing my existing CoolBot with the new CoolBot Pro. No biggie! To ensure your cooler will continue performing just as
well as always grab a pen and
write down the settings from your old CoolBot:
✓ Room Set Point: _______
Push either arrow key on your CoolBot until the Room Mode light is lit. Press
the checkmark and the current setpoint will blink.
✓ Fins Setting: _______
Push either arrow key on your CoolBot until the Fins Mode light is lit. Press
the checkmark and the current Fins Setting will blink.
✓ Heater delay: _______
Push either arrow key on your CoolBot until the Heater Mode light is lit. Press
the checkmark three times and the current Heater Delay Setting will blink.
CoolBot Pro
Temperature
Sensors
CoolBot Jumper
Heater
Power Supply
Data Cable

Store It Cold CoolBot PRO Specifications

General

Control Type	Digital
Connectivity	Wi-Fi
Display	LCD
Product Type	Temperature Controller
Compatibility	Compatible with most standard air conditioners
Mobile App	Yes, available for iOS and Android