Rev: 2017 – 11A ©2017 Store It Cold, LLC 4
POWER INDICATOR LIGHT: This light is constantly on (solid), as long as your CoolBot
is plugged in and getting the correct power supply (110V-230V).
HEATER ACTIVITY INDICATOR: During normal operation and when “calling for
cooling” this light will blink slowly. It will stop blinking if the room temperature has
reached the “set point” or the fins are reaching the freezing set point.
INPUT TOUCH KEYS
CHECKMARK KEY: Press to enter the setup menu, save values, and exit
each particular mode.
RIGHT ARROW KEY: Press to move the Mode indicator light in between
modes from left to right: Room -> Fins -> Heater -> Program -> Room
LEFT ARROW KEY: Press to move the Mode indicator light in between modes
from right to left: Room <- Program <- Heater <- Fins <- Room
ROOM AND FIN SENSOR CABLES: These two cables are interchangeable. They
monitor the room temperature and the A/C’s fin temperature.
HEATER CABLE: This cable (red tip) heats up the A/C’s sensor when cooling is needed.
POWER CORD: This standard Mini USB cable brings power to your CoolBot. It is a
power supply cord with Input of :100-240V / 50-60HZ, and output of: 5VDC and 1 Amp.
To Next Page
Loading...
