Rev: 2017 – 11A ©2017 Store It Cold, LLC 6
BEFORE INSTALLING YOUR COOLBOT
Please go through the following checklist before installing your CoolBot:
❏ The A/C Unit:
❏ Has digital display only.
❏ Is properly sized in BTUs.
To check A/C sizing visit:
https://www.storeitcold.com/buildit
❏ Is of one of the recommended brands and models.
To check A/C compatibility visit:
https://www.storeitcold.com/buildit
❏ Has Automatic Restart.
❏ The A/C is installed:
❏ High up on the cooler wall (bottom of the A/C >5 feet/1.5 meters).
❏ On a short wall if it is a rectangular room.
❏ Tipped backwards (about 1 inch) and leveled from side to side to
allow for proper draining.
❏ The Room:
❏ Ceiling and walls are insulated to R25 using Rigid Foam
(NO fiberglass).
❏ Seams, corners and door gaskets are tightly sealed.
❏ Is airtight. When I close the door of my room (standing inside), I see
no light through any cracks.
❏ Floor is insulated (only if it’s a mobile cooler, trailer, container, deck,
raised floor, or if trying to cool below 38°F/3°C).
To Next Page
Loading...
