Item 60338
Page 8
For Generator technical questions, please call 1-800-444-3353.
For Engine technical questions, please call 1-800-520-0882.
SAFETY OPERATION MAINTENANCESETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Inspect engine and equipment, looking for damaged, loose, and missing parts before set up
and starting. If any problems are found, do not use equipment until fixed properly.
Checking and Filling Fuel
WARNING! TO PREVENT SERIOUS
INJURY FROM FIRE:
Fill the fuel tank in a well-ventilated area
away from ignition sources. If the engine is
hot from use, shut the engine off and wait
for it to cool before adding fuel.
Do not smoke.
Note: Do not use gasoline containing more than
10% ethanol (E10). Do not use E85 ethanol.
Note: Do not use gasoline that has been stored in a
metal fuel container or a dirty fuel container. It can
cause particles to enter the carburetor, effecting
engine performance and/or causing damage.
CAUTION! Your Warranty is VOID if the Engine’s
Fuel Tank is not filled with the proper mixture (50:1)
of unleaded gasoline and 2-cycle oil before each
use. Before each use, check the fuel level. Do not
run the Engine with an improper unleaded gasoline/2-
cycle oil mixture. Running the Engine with an improper
mixture WILL permanently damage the Engine.
1.
1 GALLON
UNLEADED
GASOLINE
2.5 FLUID OUNCES
2-CYCLE OIL
APPROVED
CONTAINER
Figure B
The Fuel Tank holds approximately 1 gallon of fuel.
2. To obtain the proper gasoline and
2-cycle oil mixture, mix 2.5 fluid ounces of 2-cycle
oil with 1 gallon of unleaded gasoline into
an approved container. Then gently agitate the
container to thoroughly mix the gasoline/2-cycle oil.
3. To fill the Fuel Tank:
a. Wipe off the Fuel Cap and the surrounding area.
b. Unscrew, and remove the Fuel Cap.
c. Remove the Strainer and remove any dirt
and debris. Then replace the Strainer.
d. Fill the Fuel Tank to about 1 inch under
the fill neck of the Tank with the pre-mixed
unleaded gasoline/2-cycle oil mixture.
e. Replace the Fuel Cap.
Start Procedure:
Before starting the Engine:
a. Inspect the Generator and Engine.
b. Fill the Fuel Tank with the proper
amount and type of unleaded
gasoline and 2-cycle oil.
To Next Page
Loading...