Item 60338
Page 9
For Generator technical questions, please call 1-800-444-3353.
For Engine technical questions, please call 1-800-520-0882.
SAFETYOPERATIONMAINTENANCE SETUP
1. Open the Fuel Valve.
2. Turn the Engine Choke Lever to its “CHOKE” position. Set
the Choke Lever in the “RUN” position when starting a
warm Engine.
3. Turn the Engine Power Switch ON.
4. Grasp the Starter Handle and pull slowly until resistance is
felt. While holding the Handle, allow the Starter Rope to
rewind slowly. Then, pull the Starter Handle with a rapid,
full arm stroke. Once again while holding the Handle, allow
the Rope to rewind slowly. Repeat as necessary, until the
Engine starts.
5. After the Engine starts and warms up, slowly move the
Choke Lever to its “RUN” position.
IMPORTANT: Allow the Engine to run at no
load until warm (approx. 3 minutes) after each
start-up to allow the Engine to stabilize.
Open
Fuel
Valve
Close
Choke
Power ON
Open
Choke
Break-in Period:
Breaking-in the Engine will help to ensure proper
equipment and Engine operation, and will extend
the Engine’s lifespan. The warranty is void if
the Engine is not broken in properly. The first
25 hours of operation is the break-in period.
During this time frame, DO NOT exceed 75%
of the Generator’s load limit. In other words,
the maximum load during this break-in period
should be no more than 600 watts.
Under normal operating conditions subsequent
maintenance follows the schedule explained in
the MAINTENANCE AND SERVICING section.
To Next Page
Loading...