Figure 1: PLP controls.
The controls work as follows:
A - Light
B - Off
C - Position 1
D - Position 2
E - Position 3
F - Automatic stop timer
We recommend that you switch on the
hood for a few minutes before you
start cooking, and then leave it running
for approximately 15 minutes after-
wards to ensure that all odours are
extracted.
Delayed stop timer function
The “delayed stop timer function” can
be used to delay the hood stop for
15 minutes.
To set the timer function, press the
“timer” button. The “timer” neon light
will come on. The hood will continue
to operate at the speed set for 15
minutes, then switch off automatically.
Once the hood has stopped, press the
timer button again to cancel the timer
function.
Lamps
To illuminate the cooking area
underneath the hood, push the “lamp”
control button. The lamps will come
on.
To switch off, press again to return to
the “off” position.
Important safety notes
• Keep hob rings covered with pans
when switched on, to avoid
damaging the hood. The use of
an unprotected flame can cause a
fire hazard.
• Do not flambé food underneath
the hood.
• When frying foods, take care to
avoid cooking oil flares.
• Wash the grease filters regularly -
refer to the cleaning section.
• Do not check filters while the hood
is in use.
• Do not touch the lamps after
prolonged use of the appliance.
Re-circulation method only:
• Keep the air ducting vents clear of
obstruction.
• Change the carbon filters every 4
months.
3
To Next Page
Loading...
