18
To check the auto switch off
To check the timer setting for a cook zone select a
timed cook zone and then press the up [+] and down
[-] keys simultaneously to show the time remaining.
If multiple timers have been set then the timers can
be checked as follows:
1. Please ensure that no cook zones have been
selected.
2. Select the timer by pressing the up [+] and down
[-] keys simultaneously – the timer display will
show 00
3. Press the up [+] and down [-] keys as many times
as necessary to display the timer for the required
cook zone
4
(the active cook zone times are cycled
clockwise). The stationary dot in the cook
zone display will flash when the timer is
displayed for that zone.
4
If the minute minder has also been set it
will be displayed first. In this case other
timed cooking zones are shown by a
stationary dot in the cook zone display.
APPLIANCE ERRORS
Appliance Errors Fault Description Action
ER03 and
permanent tone
Continuous button actuation;
control switches o after 10
seconds
Clean the user interface.
E2 Over temperature Allow system to cool
E/H Invariable resistor fault Induction module must be cool
TROUBLESHOOTING
The hob produces a smell the first few times it is
used
Heat a pan full of water on each zone for half an hour.
Pans make a noise during cooking
This is caused by vibration due to the pas-sage of
energy from the hob to the pan. On a high setting this
is quite normal for certain types of saucepan. It will
not dam-age the hob.
The hob makes a slight clicking sound
This is caused by the distribution of power between
two heating zones on the same side of the hob.
The hob won’t work. The indicators don’t come on
The electricity supply is not reaching the appliance
(faulty supply or connection);
Check the fuses and the cut-out switch.
Refer to Troubleshooting chart and if problems
persist call, the customer service hot line for further
assistance.
The fan keeps working for a few minutes after the
hob has been turned off
There are cooling fans fitted to this appliance which
will operate when the appliance is on and until the
appliance is sufficiently cooled.
To Next Page
Loading...
