Operations Model 6DS-SP Planarizer
3 - 44 Version 4.0 - February 1998
3 - PLACE CARRIERS ON SPINDLES
NOTICE: The procedure below is for single-table machines ONLY.
For two-table machines, refer to “Carrier Loading and
Unloading for Machines Equipped with a Second Polish
Table”, located on page 3-85U.
Set carrier(s)--right, left, or both--on cleaning stations:
1. Open Left Side Operator Door.
2. Set carriers on cleaning stations, aligning each with its
load ring.
3. Close all doors to the machine.
Select the Auto Polish Cycle Menu:
Operator Action Explanation/Screen Display
4. <F9> Press the F9 key to choose
“Select Menu”.
5. <F1> Display the Auto Polish Cycle
Menu by pressing the F1 key to
select “Auto Cycle”.
To Next Page
Loading...
