1.4 Warnings (Read and understand all safety warnings before operation)
All safety warning labels are clearly depicted on the lift to ensure that the operator is aware of and avoids the dangers of
using the lift in an incorrect manner. The labels must be kept clean and they have to be replaced if detached or damaged.
Please read carefully the meaning of each label and memorize them for future operation.
1.5 Sound Level
The sound emitted from the lift should not exceed 75DB. For the sake of your health, we suggest putting a noise detector in
your working area.
1.6 Training
Only properly trained people are allowed to operate the lift. We are quite willing to provide professional training for the users
when necessary.
1.7 Special Reminder
The newly installed lift can NOT directly lift vehicle, and should be raised to the highest point then lower to the lowest point
2-3 times repeatedly without any load to bleed the air out from the hydraulic hose and cylinders to ensure the lift runs
smoothly.
1
st
time use the lift with load after air bleeding should follow the steps as below:
1. Loosen the screw cap of Hydraulic Oil Flow Valve and tighten the middle hexagonal screw clockwise inward to
the tightest.
2. Press the “UP” button to raise the lift with loaded vehicle to your desired height.
3. Press and hold the “DOWN” button to wait for the safety lock to be disengaged, then finely counterclockwise
adjust Hydraulic Oil Flow Valve (the middle hexagonal screw) to make the lowering speed reach 0.5inch/sec or
slower.
Note: The screw rotation must be adjusted by 1/8 or 1/16 as a scale.
To Next Page
Loading...