Need help?Do you have a question about the Streacom DB4 and is the answer not in the manual?
Lists all components included in the DB4 GPU cooling kit, such as mounts, heat sinks, and screws.
Details technical parameters of the DB4 GPU cooler, including TDP, heat pipe diameter, and rating.
Provides a visual breakdown and labeling of the DB4 GPU cooling kit components.
Step-by-step guide on how to detach the original cooler assembly from the graphics card, including warnings.
Instructions for cleaning residual thermal paste from the GPU die after cooler removal.
Guide on assembling the GPU mount, heat sink mount, and heat pipes, recommending center slots.
Illustrates correct heat pipe protrusion from GPU mount and depth in heat sink mount for optimal performance.
Details the proper orientation of the GPU cooler assembly for horizontal heat pipe alignment with the PCI connector.
Instructions on attaching mounting nuts to the back of the graphics card using adhesive pads for cooler attachment.
Important notice on applying thermal paste to the GPU die, heat pipes, and copper shim for effective heat transfer.
Guidance on placing the cooler onto the GPU and securing it with spring loaded screws, adjusting for pressure.
Instructions for applying miniature heat sinks to VRAM and other components for supplementary cooling.
Recommends installing the graphics card onto the motherboard first before placing it into the DB4 chassis.
Details lowering the motherboard assembly into the DB4, locking the tray, and securing the graphics card bracket.
Notes that heat pipes and mount can pivot for clearance and contact adjustment when fitting the assembly.
Guides on positioning the Heat Sink Mount (HSM) against the side panel for optimal thermal contact and performance.
Explains how to lock the HSM in place using a universal bracket and thumbscrew for stability and pressure.
Describes checking for parallel alignment between the HSM and side panel to confirm even force application.
To Next Page
General