• From the “on” mode depress and hold the button for
one second to dim, two seconds to activate the strobe
mode, and eight seconds to enter the moonlight mode
with extended runtime. An additional press of the
switch from any of these modes will turn the light off.
• The head of the Knucklehead can turn 360º on the
body and will pivot 210º from side to side.
• Use the magnet on any convenient ferrous surface to
provide task-specific illumination.
NOTE: The magnet should be attached carefully to sur-
faces as it is very powerful.
• Lift and slide out the integrated hook to hang the
Knucklehead.
ATTACHING THE MAGNET
The Knucklehead ships with the magnet detached from
the light. The attachment screw is located under the label
of the silver shipping washer. Slide off the silver shipping
washer and buffer ring and discard both parts. Place the
magnet onto the back of the Knucklehead ensuring the
post on the back of the light engages with the blind hole
in the back of the magnet. Secure the magnet by install-
ing and tightening the attachment screw with a 9/64 hex
head wrench.
CHARGING THE LIGHT (If Applicable)
The Knucklehead should be fully charged before use. In-
sert the base of the flashlight into the charger (door latch
faces out). Several charge and discharge cycles may be
needed to achieve full battery capacity. The Knucklehead
is designed to be charged continuously between uses.
Charger Description
There are two basic charger options, FAST CHARGERS
[one (1) hour recharge] and the STEADY CHARGER [ten
(10) hour recharge]. FAST CHARGERS have either a DC
cord or an AC transformer wired directly into a strain re-
lief on the charger housing. The STEADY CHARGER has
interchangeable AC and DC power cords which allow con-
nection to a variety of AC and DC power sources.
To Next Page
Loading...
