StreamLight PolyTac 90 - Streamlight PolyTac 90 Operating Instructions; Important Safety and Battery Warnings; Battery Installation and Removal; General Operation and Modes

OPERATING INSTRUCTIONS FOR STREAMLIGHT POLYTAC
®
90
IMPORTANT
WARNING: FIRE, EXPLOSION, BURN HAZARD – USE ONLY
RECOMMENDED LITHIUM BATTERIES
Inferior quality lithium batteries can cause fire, explosion, burns. We recommend the
use of
ONLY Streamlight or Panasonic, Sanyo, Energizer or Duracell batteries in our products. Use of
other batteries or mixing brands and old and new batteries may risk leakage, fire, explosion and
serious personal injury. To further avoid this risk for any brand lithium battery, do not recharge,
misuse, short circuit, disassemble, improperly store or discard, expose to high temperatures.
WARNING - Use of light in “strobe” mode may cause seizure in persons with photosensitive
epilepsy.
BATTERY INSTALLATION/REMOVAL
•
Unscrew the tailcap (remove depleted batteries).
•
Insert batteries positive end rst.
•
Replace tailcap and tighten.
GENERAL OPERATION
Switch (All fuctions from off)
Momentary
•
High: Press and hold;
release for off.
•
Strobe: Double press and hold;
release for off.
•
Low: Triple press and hold;
release for off.
Steady
•
•
High: Click the switch once to
lock on; click again for off.
Strobe: Fast double click
the switch to lock on;
click again for off.
•
Low: Fast triple click the switch
to lock on; click again for off.
D-Ring Retainer
Deployed
Spring
Gate
Operation
Stowed