GENERAL OPERATION
The ProTac® Rail Mount features a programmable switch with momentary operation (light press or tap) and constant
on operation (latching, press with increasing force until it clicks).
• High: Tap and hold; click to lock on; click again for off.
• Strobe: Fast double-tap (within 0.4 seconds) and hold; click to lock on; click again for off.
Accessing Other Programs
The ProTac® Rail Mount features a TEN-TAP® programmable switch allowing the user to select one of three different
programs. To change to the next program, starting from the “Off” position, tap the switch rapidly 9 times (within 0.4
seconds per tap) and hold it down the 10th time. Continue holding the switch until the light turns off (approximately 1
second), then release the switch.
Available programs are High-Strobe (Factory Default), High only or Low-High.
Remote Switch Operation
The ProTac® Rail Mount may be used with an optional remote switch available in momentary-only and
momentary/latching versions. To install a remote switch, insert the remote switch plug into the tailcap port. Mount
remote switch to firearm as desired.
• Both remote versions: The large pad on the remote switch functions in the same manner as a tap on the
programmable switch.
• Momentary/Latching version only: The smaller button functions the same as latching the programmable switch.
Use the pad to initiate the desired mode and then depress the latching button for constant on operation. Note,
constant on switches can conflict when using the latching remote switch. If the light does not appear to turn off, verify
both remote and tailcap switches are off.
MAINTENANCE
It is important to keep the O-ring on the tail cap lubricated. The ProTac® Rail Mount rail clamp tension bolt requires an
application of high-quality gun oil to keep it rust free. Use a soft cloth and mild detergent to clean the glass LED lens
and keep it free of dirt and grime.
Avoid aggressive cleaning solutions as they may damage the ProTac® Rail Mount. If you shoot
ammunition with an exposed lead base on the bullets, the lens and facecap may become coated with lead. This may
be removed from the lens by rubbing with fine steel wool. It is extremely difficult to remove the lead coating from the
facecap. Wrap the facecap with electrical tape to avoid lead coating.
PRODUCT USE
Streamlight flashlights are intended for use as high intensity, heavy duty, and portable light sources. Use of
Streamlight flashlights for any purpose other than as light sources is specifically discouraged by the manufacturer.
Streamlight specifically disclaims liability for other than recommended use.
Be sure to use only genuine Streamlight replacement parts to ensure product safety. Substitution
may invalidate the product approval. Do not try to repair the unit yourself. Send to a qualified service facility or return
it to the factory.
Streamlight Limited Lifetime Warranty
Streamlight warrants this product to be free of defects for a lifetime of use except for batteries and bulbs, abuse, and
normal wear. We will repair, replace, or refund the purchase price of this product should we determine it to be
defective. This limited lifetime warranty also excludes rechargeable batteries, chargers, switches, and electronics
which have a 2-year warranty with proof of purchase. THIS IS THE ONLY WARRANTY, EXPRESSED OR IMPLIED,
INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. INCIDENTAL,
CONSEQUENTIAL, OR SPECIAL DAMAGES ARE EXPRESSLY DISCLAIMED EXCEPT WHERE SUCH LIMITATION IS
PROHIBITED BY LAW. You may have other specific legal rights which vary by jurisdiction.
Go to streamlight.com/support for a complete copy of the warranty. To register your product, go to streamlight.com
(Online Product Registration). Retain your receipt or any proof of purchase.
SERVICE OPTIONS
To Next Page
Loading...
