StreamLight SL-B26 User Manual

OPERATING INSTRUCTIONS FOR THE STREAMLIGHT
®
LI-ION BATTERY BANK CHARGER
SAFETY
 SAVE THESE INSTRUCTIONS. This document contains important safety, operating and maintenance
information for your charger.
 CAUTION: To reduce risk of fire, electrical shock, or personal injury, do not attempt to use this charger
to recharge other manufacturer’s batteries.
 Do not use a damaged charger.
 Do not place any metal objects onto the charging terminals located in the charger.
 Do not disassemble or try to repair the charger. Return it to a qualified service facility or the factory.
 Use only Streamlight
®
SL-B26™ protected Li-Ion USB rechargeable battery pack P/N 22101 or 220115.
Recycle worn out or damaged battery packs properly.
 CAUTION: To reduce risk of fire, electrical shock, or personal injury, handle the battery pack carefully
and never allow it to short circuit. Do not incinerate the battery pack as it may explode in a fire.
CHARGER
The Li-Ion battery bank charger is available with the following power supplies: 120VAC power supply,
International Power supply or 12 VDC “flying lead cord” for vehicle installations.
Charge cord installation:
1. Insert the 2.5mm barrel connector from the cord into the power jack on the back of the charger.
2. Route the charge cord under the retaining tabs with the end of the cord exiting through either the
bottom or side slot in the charger.
Connect the AC power supply or International power supply to a wall outlet for wall mounted operation or
connect the barrel plug with flying leads for vehicle mounted operation (see INSTALLATION IN
VEHICLES below).

StreamLight SL-B26 Specifications

General

Output Voltage	4.2 VDC
Charge Time	3 hours
Input	AC
Compatible Battery Types	SL-B26 protected Li-Ion USB rechargeable battery pack
Charging Indicator	LED
Input Voltage	100-240 VAC, 50-60 Hz

Summary

Safety Information

General Safety Precautions

Key safety warnings and precautions for using the charger and battery packs, including fire and shock risks.

Charger Operation

Charge Cord Installation

Instructions for connecting the charger's power cord, including routing and attachment points.

Charging Procedures

Battery Pack Charging

Step-by-step guide on inserting battery packs into the charger and initiating the charging process.

LED Charge Indicators

Explanation of the LED lights indicating charging status (charging, charged, error) and their meanings.

Charger Mounting and Installation

Mounting Guidelines

Recommendations and requirements for safely mounting the charger, including location and screw type.

Vehicle Installation

Detailed steps and considerations for installing the charger in a vehicle environment using a 12VDC power cord.

Warranty and Service