USING THE AIR COMPRESSOR
WARNING: Check item to be inflated for manufacturer’s maximum recommended inflation pressure. Avoid over inflation.
Most tires are properly inflated between 24-35 PSI. Some truck and bicycle tires require 40 PSI or more.
To inflate tires:
1. Remove valve cap from air valve stem.
Note: Make sure locking thumb lever is at up position. If necessary, use valve stem adapter.
2. Insert stem connector to valve stem. Make sure connector is pushed to valve stem as far as possible.
3. Press down the locking thumb lever to engage.
4. Set the compressor on/off switch to “on” position by pressing down the section
of switch marked “I”. Note: In the event that the tire is completely flat, raise the vehicle using a recommended jack before
inflating the tire.
5. Monitor pressure on air pressure gauge. Note: It is recommended to use a separate air gauge to check the actual inflation
pressure. When desired pressure is reached, turn off compressor, turn the locking thumb
lever to up position and remove stem connector from valve stem. Also remove valve stem adapter if applicable.
6. Replace valve cap on valve stem.
To inflate plastic inflatable (balls, air mattresses, rubber rafts, etc.):
1. Check manufacturer’s specification on item to be inflated for correct inflation pressure.
2. Remove valve cap cover from valve stem.
3. Insert proper valve stem adapter into stem connector as far as possible and turn the locking thumb
lever to down position.
4. Insert other end of valve stem adapter into inflatable air valve stem as far as practical.
5. Set the compressor on/off switch to “on” position.
6. Monitor pressure on air pressure gauge. When desired pressure is reached, turn off compressor, turn the locking
thumb lever to up position and remove stem connector from valve stem. Also remove valve stem adapter if applicable. Replace
valve cap on valve stem.
WARNING: EXPLOSION HAZARD!
DO NOT EXPOSE BATTERY TO FIRE OR INTENSE HEAT AS IT MAY EXPLODE.
BATTERY CONTAINS NON-SPILLABLE SEALED LEAD ACID BATTERY: IF CASE SHOULD BECOME CRACKED,
DISPOSE OF IMMEDIATELY TAKING ADEQUATE SAFETY PRECAUTIONS TO PREVENT INJURIES OR DAMAGE TO
PERSONS OR PROPERTY. BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.
SPECIFICATIONS
Power Supply Battery: 15AH sealed lead acid
Power Supply DC Output: 12 Volts nominal
Air Compressor: 290 PSI
Power Supply Charging Time: 38 hours for the first time charging with AC charger; 34-36 hours to
recharge with AC charger and 12-14 hours to recharge with 12-volt DC charger.
Storage Temperature: Store in a cool dry area
IMPORTANT: ADDITIONAL SAFETY INFORMATION
This Power Station/Emergency Jumpstart is NOT intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they are supervised or have been given instruction concerning use
of the Power Station/Emergency Jumpstart by a person responsible for their safety.
The WEEE symbol on this product means that this product should be
ethically dismantled or recycled tominimise environmental impact.
Please check with your local authority for more information.
For product support:
E: support@streetwizeaccessories.com
T: +44 (0)161 447 8597
For trade enquiries:
E: sales@streetwizeaccessories.com
T: +44 (0)161 447 8580
For spare parts:
E: spareparts@streetwizeaccessories.com
Streetwize: Ashburton Road West,
Trafford Park, Manchester M17 1RY
www.streetwizeaccessories.com
EU Registered address: The Ace Supply Co (Europe) Ltd, 25 Herbert Place, Dublin 2, D02 A098 Republic of Ireland.
To Previous Page
Loading...
