Strend Pro BL-198DLR - Operation; Before First Use; Switching On;Off; Air Velocity Level Adjustment

COOL – cooling and humidification function
SWING – blow function (fan)
TIMER – timer setting
WIND – airflow type setting
SPEED - airflow level adjustment
ON/OFF – device switch on/off
OPERATION
BEFORE FIRS USE
Wheels instalation
- Place the air cooler on a level surface and mount the wheels.
Filling the water tank:
- Pull the water tank out of the appliance and fill it to 1/3 with clean water.
- Make sure that the amount of water in the tank is not lower than the minimum value "min" but also not
higher than the maximum value "max".
Inserting the ice box:
- To increase the cooling efficiency, you can put an ice bucket in the water tank.
- 2 ice buckets are supplied with the appliance.
- Fill the ice bucket with clean water, close with a cap, put in the freezer and let it freeze.
Warning: When filling the ice bucket, make sure that you do not exceed the maximum value "max".
Overfilling could lead to its rupture.
- After the water in the container has completely frozen, remove the ice container from the refrigerator. Open
the cap and place the ice bucket in the appropriate holder in the water bucket. Make sure that the amount
of water in the tank does not exceed the maximum value "max".
SWITCHING ON / OFF
- Before connecting the air cooler to the power supply, make sure that the voltage in your electrical outlet
corresponds to the information on the rating plate.
- Check the power cord for damage. If it is, do not use the device and have the power cord replaced by an
authorized service center to avoid danger.
- Connect the appliance to the power supply by inserting the plug into the mains socket.
- Press the ON / OFF button to switch on the device
- "LOW" (low airflow level) lights up on the control panel LED.
- Press the OFF button to switch off the device.
AIR VELOCITY LEVEL ADJUSTMENT
- During operation, press the SPEED button.
- "MIDDLE" (medium airflow level) lights up on the control panel LED.
- By pressing the SPEED button again, "HIGH" (high airflow level) lights up on the LED indicator of the control
panel.
- By pressing the SPEED button again, "LOW" (low airflow level) lights up on the LED indicator of the control
panel.
AIR VELOCITY TYPE SETTING
- During operation of the device, press the “WIND” button to select the type of air flow.
- The icon for the selected airflow type lights up on the control panel LED.
"NORMAL" (standard operation mode) - Continuous airflow that can be set to low, medium and high airflow.
"NATURAL" mode - Provides a soft and comfortable environment with the ability to set low, medium and
high airflow levels.
"SLEEP" - Operates in natural mode and slowly reduces the airflow speed before turning it off. At high airflow