levels, the device switches to medium airflow level after 30 minutes and then to low airflow level after 30
minutes where it is in operation for 30 minutes before shutting down or until the end of the preset time.
TIMER SETTING
- Use the TIMER button to set the air flow time in the range of 1-12 hours.
- The selected time is displayed on the control panel LED.
- The air cooler will operate until the set time has elapsed.
- Press the TIMER button as many times as you want to set the cooler.
- To cancel the timer, simply press the TIMER button until "00" appears on the control panel LED.
BLOW FUNCTION (FAN)
- Activate the blow function by pressing the "SWING" button.
- The icon lights up on the control panel LED and the fan blades begin to move left and right.
- The vertical direction of the air flow can be adjusted manually by directing the output blades up and down.
- Deactivate the blow function by pressing the "SWING" button again.
COOLING AND HUMIDIFICATION FUNCTION
- Air cooling works on the principle of evaporating cold water, which removes heat from the intake air and at
the same time this air is humidified by the resulting steam.
Important: Make sure there is enough water in the water tank before switching on the cooling function. Do
not switch on the function if there is not enough water in the water tank.
- Press the "COOL" button to activate the cooling function.
- Deactivate the cooling function by pressing the "COOL" button again.
IONIZATION FUNCTION
- Activate the ionisation function by pressing the "ION" button.
- The icon lights up on the control panel LED.
- The intake air passes into the cooler through an air filter, which cleans it of dust and other impurities.
REMOTE CONTROL
- The remote control works on CR2025 coin cell batteries.
- Point the remote control at the air cooler control panel.
- If the remote control does not work, check the batteries first and replace them if necessary.
- If you do not use the remote control for a long time, remove the batteries to prevent possible damage due
to battery leakage.
MAINTENANCE
- Before cleaning the appliance, disconnect it from the power supply and let it cool down.
- The protective cover of the air cooler is easily soiled, so clean it regularly with a soft cloth. On very dirty
parts, use a damp cloth in soapy water, the temperature of which is less than 50 ° C. Then dry the heater
protection cover with a clean, dry cloth.
- Make sure that water does not get inside the appliance. Do not splash water on the air cooler and never
use solvents such as benzine, isoamyl acetate, toluene, etc. to clean it.
- Keep the air cooler clean and let it cool down before storing. Store in a dry, well-ventilated place.
CLEANING THE AIR FILTER
- Remove the air filter from the appliance and clean it with commercially available cleaning agents and
brushes. Allow the air filter to dry completely and then reinstall it in the unit.
CLEANING THE WET CURTAIN PAPER
- Remove the wet curtain paper from the appliance and clean by neutral cleaner and soft brush. Allow the
wet curtain paper to dry completely and then mount back to the appliance.
To Next Page
Loading...