1. Before using the receiver for the rst time, you must pair it with your phone.
2. Press the multifunction button for about 3 seconds until the blue and red lights start ashing
alternately.
3. Turn on the Bluetooth function of your phone.
4. Search for the Bluetooth devices and select “Strex Receiver”
5. Enter the code “0000” if needed.
6. If pairing is successful, the indicator light ash will ash blue slowly.
1. Pair the Bluetooth receiver to the rst phone.
2. After pairing successfully, turn o the Bluetooth function of the rst phone.
3. It will enter pairing mode again.
4. Pair the Bluetooth receiver to the second phone.
5. After pairing successfully, Turn on the Bluetooth function of the rst phone. Two phones will
both connect the Bluetooth receiver at the same time.
PAIR WITH YOUR PHONE
CONNECT TWO BLUETOOTH DEVICES AT THE SAME TIME
1. It will connect the last connected phone automatically when it turns on. (Please make
sure the Bluetooth function of your phone is on before turning on the receiver.)
If you want to switch song from the rst phone to the second, just play the song on your second
phone, and press the multifunction Button, then you can Enjoy the second song right now.
REMARK
REMARK
ANSWERING A CALL
For iPhone users:
For Android User (such as Samsung, HTC, Sony etc.):
Selection 1. Press the multifunction button.
Selection 2. Press the “Answer” button of your iPhone and check your iPhone call menu. Look for
the audio source and select the “Strex Receiver”
Selection 1. Press the multifunction button.
Selection 2. Press the “Answer” button of your phone.
6
To Next Page
Loading...