6
INTRODUCTION AND INSTALLATION
Before using you must charge the battery (during storage it may have lost part of its load).
To do this, plug the charger into a power outlet and connect it to the battery, the battery
must be disconnected from the sprayer.
Note that the charger indicator is green when it is plugged into the power outlet, and turns
red when the battery has begun charging. When the battery is fully charged the indicator
changes from red to green. The operating temperature range of the sprayer is 33ºF to
122ºF.
Follow these steps to put together your backpack sprayer:
1.
Install the wand holder onto the sprayer tank
2.
Insert the battery pack in its housing, to do this you open the door at
the back of the sprayer and insert it into the correct position until the
lever lock/unlock is locked.
3.
Remove the cap and, using the load filter, pour the liquid in the tank. Replace
the c
ap and tighten securely.
4.
Place the sprayer on an elevated surface, ensure that the straps are
firmly attached to the tank and pull straps on your shoulders.
5.
To start working with the model GS18AS-15 (2 speeds), determine if you
want to set the pressure to low or high.
Low speed (low pressure)
Pr
ess the button down LED light changes to green when in use
High speed (high pressure)
Press the button up LED light changes to green when in use
To turn the sprayer off set the switch to the middle position
To Next Page
Loading...