EasyManua.ls Logo

Stromag KMB 2 ZM - User Manual

Default Icon
96 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Druckmittelgeschaltete
Lamellen-Federdruckbremse
KMB-ZM, KLB-ZM
Dokumenten-Nr.: 777-00001 D
Datum: 10.2017
SKB-0398
Montageanleitung
DE
Stromag GmbH
Hansastraße 120
D-59425 Unna
Tel.: +49 (0) 2303 102-0
Fax: +49 (0) 2303 102-201
www.stromag.com
info@stromag.com

Table of Contents

Questions and Answers

  • A
    Amanda FordAug 7, 2025
    What to do if the braking action is insufficient in Stromag KMB 2 ZM?
    • Y
      ywilsonAug 7, 2025
      If the braking action of your Stromag Industrial Equipment is insufficient, it could be due to several reasons. One potential cause is that the inner disc was not degreased when it was replaced. In this case, degrease the friction surface. Another reason might be that the permissible wear has been exceeded, so replace the disc pack. Finally, there might be residual pressure present in the pressure line, so check the cause and find a corrective action.
  • D
    Derek PerezAug 23, 2025
    Why is the Stromag Industrial Equipment brake too warm?
    • C
      Corey SavageAug 23, 2025
      If your Stromag Industrial Equipment brake is too warm, it could be due to the minimum excessive release pressure for opening the brake not being present. Check this using the dimensional drawing. Alternatively, if the lubricant is too thick, causing idling heat, you should contact Stromag's Customer Care.

Summary

For your safety

Safety Concepts and Personnel Qualifications

Explains the safety structure and required personnel qualifications for tasks.

Intended Use and Application Limits

Defines the brake's purpose, power supply, and application limits.

Critical Safety Warnings

Covers risks in explosive atmospheres, non-intended use, residual risks, and general dangers.

Mechanical and Thermal Dangers

Details risks from mechanical failures and contact with hot components.

Hazard Classifications and Mandatory Symbols

Defines hazard levels (DANGER, CAUTION) and mandatory personal protective equipment.

Operator Responsibilities and Equipment Safety

Operator duties, safety devices, PPE, and safe handling responsibilities.

Safe Handling Practices

Guidelines for handling suspended loads, rotating components, pressurized media, and hot surfaces.

Transport and storage

Special Safety Guidelines for Transport

DANGER and CAUTION warnings regarding lifting, moving, and handling loads.

Storage Conditions

Assembly

Assembly Safety and Preparation

Safety guidelines and pre-mounting conditions including corrosion protection.

Tightening Torques and Connecting Components

Brake Installation and Medium Line Mounting

Operation

Operation Safety and Commissioning

Safety guidelines and initial commissioning steps like foil removal and system flushing.

Maintenance and inspections

Maintenance Safety, Environment, and General Points

Safety guidelines, environmental measures, and dangers from spring pressure.

Maintenance and Inspection Intervals

Disassembly and Component Replacement

Procedures for disassembling the brake and replacing disc packs or sealing rings.

Troubleshooting

Operational Issues and Solutions

Disassembly

Disassembly Safety and Procedures

Dismantling and Final Decommissioning

Ordering spare parts

Data for Ordering and Service Address

Stromag KMB 2 ZM Specifications

General IconGeneral
BrandStromag
ModelKMB 2 ZM
CategoryIndustrial Equipment
LanguageEnglish

Related product manuals